MaxxECU

Collet EGT sensor Used with a 4,7mm thick sensor.

3Connector 3-socket housing for eg Honeywell sensor, including pins and seals.

EGT cable for easy extension of EGT cables. Yellow/red chromel/alumel, black. 3mm thickness.

EGT plug stainless. 1/8 NPT 27.

Includes both sensor and electronics for outputting 0-5v signal. Sensor for exhaust gas temperature measurement (EGT) with 1.8m cable. mini type-k contact. 1/8 NPT.

Sensor for exhaust gas temperature measurement (EGT) with 1.1m cable. 1/8 NPT.

Sensor for exhaust gas temperature measurement (EGT) with 1.8m cable. mini type-k contact. 1/8 NPT.

Sensor for exhaust gas temperature measurement (EGT) with 1.8m cable. mini type-k contact. 1/8 NPT.

Sensor for exhaust gas temperature measurement (EGT) with 1.8m cable. 1/8 NPT.

5m cable harness for the MaxxECU Expansion Module.

Extends ANY MaxxECU over CAN with the following inputs and outputs:

Requires the MTune 1.161 preview 1 or newer to function properly.Extends ANY MaxxECU over CAN with the following inputs and outputs:

Antenna for the GEN2 MaxxECUCustom-made SMA antenna to fit GEN2 MaxxECU

Mounting brackets for MaxxECU GEN2.Includes brackets, lists, rubber bushings, and all screws for both sides of the ECU.

3 meter long, 480mbit/s.

3meter, 480mbit/sRight-angle (90°) USB-C connector on the MaxxECU side.

3meter, 480mbit/s

3meter, 480mbit/sRight-angle (90°) USB-C connector on the MaxxECU side.

34-pin superseal 1.0. Including terminals.

34-pin superseal 1.0. Including terminals.

34-pin superseal 1.0. Including terminals.

34-pin superseal 1.0. Including terminals.

AN3 MAP sensor nipple for GEN2 MaxxECU units.BSP 1/8 inch thread.Black anodized aluminum.

MAP sensor hose nipple for GEN2 MaxxECU units.BSP 1/8 inch thread.Black anodized aluminum.

All cables are 3m long.

All cables are 3m long.

All cables are 3m long.

All cables are 3m long.

Only for MaxxECU GEN2 TRACK.All cables are 3m long.Extends the MaxxECU GEN2 TRACK with input and output functions.

34-pin superseal 1.0.Including terminals and plugs to cover unused pins on the GEN2 TRACK.We are currently awaiting a custom-made connector with MX3 keying, designed exclusively for the MaxxECU GEN2 TRACK, without holes for the unused pin positions. Until it becomes available, product will be...