Electronics

Weld-on aluminum flange for Bosch Motorsport DBW throttle body e-throttle. O-ring included in the kit. M6x1mm threads in the flange. Mounting bolts not included. Fits Bosch Throttle Body pn 0280750156

CAN module for MaxxECU to extend the number of Wideband sensors in the system, works on all MaxxECU units. Including connectors, Bosch LSU 4.2 sensor.

Sensor for exhaust gas temperature measurement (EGT) with 1.8m cable. mini type-k contact. 1/8 NPT.

The Communication board needed to be able to communicate with the BMW BSD protocol.

Intake temperature sensor (IAT) M12X1.5. Very fast sensor because the element itself is open. Read temperatures up to 150 degrees. Supplied without connectors. Calibration table and connection see Figure 2. Ref:Bosch 0 280 130 039

Weld-on aluminum flange for Bosch Motorsport DBW throttle body e-throttle. O-ring included in the kit. M6x1mm threads in the flange. Mounting bolts not included. Fits Bosch Throttle Body pn 0280750151

Sumitomo injector connector, high key type, 2-pin.

Connector for VAG electronic throttle (DBW) pedals, 6-pin.

Rubber dust cover for fuel pump terminals.

Rubber dust cover (boot) for 6-7 pin connectors.

Connector for VAG applications, 4-pin (2x2).

Connector for Toyota JZ-series A/C applications, 4-pin.

Connector for Subaru ignition coils, 4-pin.

Connector for Mercedes crankshaft position sensors, 2-pin.

Connector for GM ignition coils, 7-pin.

Connector for Subaru temperature sensors, 3-pin.

Connector for VAG flex fuel (ethanol content) sensors, 3-pin. OE reference 4F0 973 703.

Connector for GM crankshaft position and MAP sensors, 3-pin.

Connector for GM LS Gen4 knock sensors, 2-pin.

Connector for Bosch LSU 4.9 wideband lambda sensors (guide type), 6-pin.

Connector for Ford throttle position sensors (TPS), 3-pin.

Connector for Toyota JZ-series speed sensors, 3-pin.

Connector housing for Bosch ABS sensors (DF11S type), 2-pin.

Mounting brackets for MaxxECU PRO.Includes brackets, lists, rubber bushings and all screws.

Mounting brackets for MaxxECU GEN2.Includes brackets, lists, rubber bushings, and all screws for both sides of the ECU.

Antenna for the GEN2 MaxxECUCustom-made SMA antenna to fit GEN2 MaxxECU

Must be mounted for the unit to be water-protected.

34-pin superseal 1.0.Including terminals and plugs to cover unused pins on the GEN2 TRACK.We are currently awaiting a custom-made connector with MX3 keying, designed exclusively for the MaxxECU GEN2 TRACK, without holes for the unused pin positions. Until it becomes available, product will be...

AN3 MAP sensor nipple for GEN2 MaxxECU units.BSP 1/8 inch thread.Black anodized aluminum.