Electronics

Ignition module. 5-pin connector:5: IGN1 in4: IGN2 in3: Earth2: IGN3 in1: IGN4 in 4-pin connector1: IGN1 out2: IGN2 out3: IGN3 out4: IGN4 out Hueco ignition module

Solenoid valve with twin coil 12VDC. Supplied with connectors and nipples. A: top on wastegateB: bottom on wastegateIN: PressureEX: Filter (OUT)

Measure 0-1250 C (TYPE-K) and send out 0-5v signal. Works with MaxxECU.

Requires 12mm hole in intake / pressure pipe and have a bolt fastening hole. Measures up to 120 degrees. Calibration table and connection see Figure 2.

Braided cable sleeve that both protects cables and provides very nice and professional installations.

Bosch Motorsport ignition coil waste fire. PIN 1: Input (2 & 3) PIN 2: 12V + PIN 3: Input (1 & 4)

Braided cable sleeve that both protects cables and provides very nice and professional installations.

Braided cable sleeve that both protects cables and provides very nice and professional installations.

Braided cable sleeve that both protects cables and provides very nice and professional installations.

Very flexible mounting brackets for cooling fans and smaller coolers such as oil coolers. Fits perfectly with SPAL cooling fan. You push the clip through intercooler or water cooler core and then through the fan or oil cooler. Then press the locking clip that...

High quality crankshaft sensor. Inductive. 1: signal2: ground3: shield

Mototron ignition coil.A very affordable alternative where the VAG ignition coil is not enough. Same ignition coil as AEM's "smart coil". Connector not includedPin A: Signal from ECU.Pin B: GND.Pin C: GND.Pin D: GND.Pin E: + 12V. Deliver CDI-like spark energy-No CDI Module needed...

Ethanol fuel sensor mounted in vehicle's return fuel line. +/- 5% accuracy, can handle temperatures between -40 and + 90 degrees C. Max 10bar pressure! AN connectors and connectors are not included, can be purchased separately, AN6 and AN8 are available. MaxxECU has direct...

VAG ignition coil AUDI VW Vag ignition coil can handle over 300hp / cyl. Length: 160mm NOTE! Only ignition coil, not supplied with connector. Make sure that the rubber part against the spark plug is lubed so dismantling of the coil gets easy. This...

Pressure sensor measuring up to 700kPa (6bar overpressure). Made for air and oil.1/8" -27 NPT connection. Electrical connector not included.

VAG ignition coil extra long. Fits BMW. Total length: 178mm (of which 35mm is the ignition coil itself) Only ignition coil, not supplied with connector. Make sure that the rubber part against the spark plug is lubed so dismantling of the coil gets easy....

Intake temperature sensor (IAT) M12X1.5. Very fast sensor because the element itself is open. Read temperatures up to 150 degrees. Supplied without connectors. Calibration table and connection see Figure 2. Ref:Bosch 0 280 130 039

Bosch Wide band sensor LSU 4.2. Used for many after market engine management systems like: Nira i3 / +MaxxECULink / VipecVEMS Bosch partnr:0258007057

Bosch TPS sensor. Fits several aftermarket ECU. Calibrated with Nira I3 + / I7 and MaxxECU PIN: 1: ECU ground 2: + 5v from ECU 3: 0-5V output CC bolt hole: 55mm The rotary potentiometer in the sensor is not centered. The dimensions can...

Bosch Wideband Lambda LSU 4.9 Used for many aftermarket ECUs Part no: 0258017025 Total length: 100CM

SPAL cooling fan 225mm / 9" suction Voltage: 12 V Power consumption: 70 W Engine type: Long life IP68 (6,8 A)Specification: 1-speed, suctionVolume: max 1060 m³/h Diameter [mm]: 225 mm / 9"Depth: 51 mm Weight: 1,0 kg

SPAL cooling fan 330mm / 13" suction Voltage: 12 V Power consumption: 105 W Engine type: Long life IP68Specification: 1-speed, suctionVolume: max 1980 m³/h Diameter [mm]: 330mm / 13"Depth: 62mm Weight: 1,52kg

SPAL cooling fan 280mm / 11" suction Voltage: 12 V Power consumption: 75 W Engine type: Long life IP68 (6,7 A)Specification: 1-speed, suctionVolume: max 1280 m³/h Diameter [mm]: 280 mm / 11"Depth: 51 mm Weight: 1,1 kg

SPAL cooling fan 350mm / 14" suction Voltage: 12 V Power consumption: 80 W Engine type: Long life IP68 (6,7 A)Specification: 1-speed, suctionVolume: max 1620 m³/h Diameter [mm]: 350 mm / 14"Depth: 51 mm Weight: 1,3 kg

SPAL cooling fan 280mm / 11" blowing Voltage: 12 V Power consumption: 80 W Engine type: Long life IP68 (6,7 A)Specification: 1-speed, blowingVolume: max 1290 m³/h Diameter [mm]: 280 mm / 11"Depth: 51 mm Weight: 1,1 kg

SPAL cooling fan 225mm / 9" blowing Voltage: 12 V Power consumption: 75 W Engine type: Long life IP68 (6,8A)Specification: 1-speed, blowingVolume: max 1030 m³/h Diameter [mm]: 225mm / 9"Depth: 51 mm Weight: 1,0 kg

SPAL cooling fan 350mm / 14" blowing Voltage: 12 V Power consumption: 70 W Engine type: Long life IP68Specification: 1-speed, blowingVolume: max 1620 m³/h Diameter [mm]: 350mm / 14"Depth: 51 mm Weight: 1,3 kg

SPAL cooling fan 330mm / 13" blowing Voltage: 12 V Power consumption: 95 W Engine type: Long life IP68Specification: 1-speed, blowingVolume: max 2010 m³/h Diameter [mm]: 330mm / 13"Depth: 62mm Weight: 1,52 kg

Black shrink tubing hose with glue making it weatherproof, which provides a strong protective seal against liquids & moisture. Delivered in lengths of 1.2m. Temp. Range -55 - + 110 ° C, . Shrinking temp. + 120 ° C.

Black shrink tubing hose with glue making it weatherproof, which provides a strong protective seal against liquids & moisture. Delivered in lengths of 1.2m. Temp. Range -55 - + 110 ° C, . Shrinking temp. + 120 ° C.

Black shrink tubing hose with glue making it weatherproof, which provides a strong protective seal against liquids & moisture. Delivered in lengths of 1.2m. Temp. Range -55 - + 110 ° C, . Shrinking temp. + 120 ° C.